Inspect a Forklift
OSHA and HRSDC report that over 10,000 workplace injuries related to fork lifts happen every year. Operator error is the reason for many of these mishaps. Lack of appropriate equipment inspection and maintenance causes many others. Forklift operation and maintenance is not just the cause of personal injuries, but also of property damage. Forklifts could damage building structures, overhead pipes and sprinklers, and other machinery when used improperly. The following day by day inspections must be performed so as to reduce the chance of forklift mishaps.
Turn the engine off prior to checking different fluid levels: fuel, engine oil, brake fluid, hydraulic oil and coolant. The tires must be inspected for indications of wear and tear. Check the air pressure in the tires. Check the forks' condition. The load backrest need to be attached securely. Do a visual inspection of the top-clip retaining heel and pin. After that carry out an inspection of the mast chains, hydraulic hoses, cables and stops. Ensure that the overhead and finger guards are firmly attached.
The LP fueled forklift has propane tanks which have to be checked for damage, rust or corrosion. The battery's charge and electrolyte levels have to be tested every so often. Seat belts have to be inspected for wear and tear. Check to make sure the owner's instruction manual is kept on-board the forklift inside a storage compartment. Test the seat belt to make certain the latches are secure. Test the hood latch to make certain that it is working as it should.
Start the forklift and listen to the noise of the engine to make sure there are no unusual sounds. If there are, investigate at once. Check the steering controls and the accelerator. The parking break and the service break must be functioning correctly.
The drive control and tilt control should be inspected to guarantee proper functioning in both reverse and forward. Check the functioning of the hoist and lowering control, and the attachment control. Test the lights and horn. Then check the heater, defroster and wipers to make certain they are functioning well. Inspect each gauge to find out that it is reading within functional limits.