In the majority of situations, most individuals spend quite a bit of money buying their lift truck. Hence, it is extremely essential to take good care of it so as to protect your investment well into the long run. It is a great idea to know the procedures which are undertaken during the care and maintenance of this piece of equipment.
Among the best ways to tell how good the engine is running is by starting the lift truck up and listening closely to see how it runs. Like for instance, if there are any knocks or misses, the machinery is defective and this should raise several concerns. Moreover listen carefully for any squealing sounds which come from the belts because these sounds would provide you with a lot of information.
When performing maintenance, several of the main parts you would have to pay attention to comprise the safety warning devices, horn, the lights, the gauges and the overhead guard. Any faulty components or burnt out light bulbs should be replaced as soon as they are noticed. It is also essential to inspect the wiring.
The battery compartment terminals should be cleaned when the above parts have been inspected carefully. If the terminals are not clean, be sure to clean them properly. Each and every battery cell must be checked so as to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and after that change the filters. The transmission filter, fuel filters and the hydraulic filter should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be done. If there is a grease fitting on the axle make certain to apply some grease. Inspect the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, inspect every other part of the equipment including the wheels. If any type of problem or fault is detected, be sure to address it immediately in order to make certain the machinery is running at its safest and optimum levels.